ALATAS’ SERVICEENGENEERING AND DESIGN
LOCATION  ASIA / LIBYA  
EQUIPMENT  GENERAL PURPOSE CARGO OFF SHORE CRANE
BRANDTTS-NORLIFT AS /  GPCO 500 – 0525

Intro

Alatas Engineering and Design Services conducted a pre- and post-weld comparative assessment of the jib structure of a general-purpose cargo crane installed on an FPSO. This study assessed the stress and deformation behavior of the jib structure’s original weld seams (by OEM) versus new weld seams introduced per the provided repair schematics. Finite element stress analysis was performed on the plated structure of the jib to simulate the distribution of stresses and corresponding weld seam contact stresses.

Background

Due to deterioration, the TTS-Norlift AS® General Purpose Cargo Offshore Crane had been underutilized for its maximum 5Te SWL capacity. The end user performed structural re-plating work, introducing new weld seams in certain jib areas. After a third-party assessment, the client wanted to return the crane to full loading capacity and approached Alatas AEDS to conduct a pre- and post-weld repair assessment FEA study.

Alatas’ Solution

3D models were created in Inventor® for both the pre-weld jib structure (original condition) and the post-weld jib structure (repaired condition) with new repair plate segments and weld seams. These models utilized standard rolled plate mechanical properties according to the provided general arrangement drawing and jib repair schematics.

Finite element stress analysis was performed on the plated jib structure to simulate stress distribution and corresponding weld seam contact stresses. Ansys® simulations were conducted for both the original and repaired jib structures to assess stress and deformation behavior, excluding the tip sheave assembly.

The Alatas AEDS design team conducted this study.

Job Scope

  • Review of jib crane operational data and hoisting capabilities.
  • Creation of 3D models for the original and repaired jib structures.
  • Creation of 1-Fall offboard SWH1.6m dynamic loads for various boom radii and angles for input to the FEA simulation based on the OEM’s applicable design standard.
  • Analysis of the original jib structure under applied design loads at various jib radii and angle configurations.
  • Analysis of the repaired jib structure under applied design loads at various jib radii and angle configurations.
  • Verification of stress variances between analyses to determine the suitability of the repaired structure.
  • Provision of a design summary report describing the findings and study recommendations.

Scroll to Top